Craftmade Outdoor Ceiling Fan Ceiling Fan User Manual

0

Out of 0 Ratings

Owner's of the Craftmade Outdoor Ceiling Fan Ceiling Fan gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 23
 
5. Fan Assembly.
If you wish to extend the hanging length of
your fan, you must remove the hanging ball
from the 4½in. downrod provided to use with
an extended downrod (sold separately). [If you
wish to use the 4½in. downrod, please proceed to
instructions following the dotted line below.]
To remove hanging ball, loosen set screw on
hanging ball, lower hanging ball and remove
stop pin. Slide hanging ball off the original
downrod, A, and slide it down the longer
downrod, B (the top of the downrod should be
noted as having a set screw hole; use this hole
when setting the set screw). Insert stop pin into
top of extended downrod and raise hanging
ball. Be sure stop pin aligns with slots on the
inside of the hanging ball. Tighten set screw
securely.
Tip: To prepare for threading electrical wires
through downrod, apply a small piece of
electrical tape to the ends of the electrical
wires--this will keep the wires together when
threading them through the downrod.
Locate canopy cover in hardware pack. Loosen
yoke set screws and nuts at top of motor
housing. Remove pin and clip from motor
housing yoke. Slide downrod through canopy,
canopy cover and yoke cover. [Note: Canopy
cover must be turned with shiny side toward
the motor.]
Thread safety cable and electrical wires
through downrod and pull extra wire slack
from the upper end of the downrod.
Thread downrod into the motor housing yoke
until holes for pin and clip in downrod align
with holes in yoke--make sure wires do not get
twisted. Re-insert pin and clip. Securely tighten
yoke set screws and nuts. Lower yoke cover to
motor housing.
["Fan Assembly" continued on next page.]
NOTE: The important safety precautions and
instructions appearing in the manual are not meant
to cover all possible conditions and situations that
may occur. It must be understood that common
sense and caution are necessary factors in the
installation and operation of this fan.
page 4
downrod
electrical wiring
canopy
yoke cover
motor
housing
yoke set screw
clip
pin
canopy cover
safety cable
pin
clip
set screw hole
set screw
hanging ball
stop pin
A
B

   Find Your Products By Category