0
Owner's of the Fanimation Fan Fanimation HF6050BZ Hf Standard Coffee Blade Ceiling Fan In Bronze gave it a score of 0 out of 5. Here's how the scores stacked up:
6
Clevis Pin
Setscrew (2)
How to Assemble Your Ceiling Fan
Pin
Setscrew
Hanger
Ball
Figure 1
1. Prior to assembly, set aside and save the hardware
bag(s) packed in the packing.
2. Remove the Hanger Ball by loosening the setscrew
in the Hanger Ball until the ball falls freely down the
Downrod. (Figure 1) Remove the Pin from the Downrod,
then remove the Hanger Ball. Retain the Pin and Hanger
Ball for reinstallation in Step 8.
3. The fan comes with support cable, black and white 80˝
wires. Separate and untwist the wires & cable. Route the
wires & cable through the Downrod.
NOTE: You will be using either the 6˝ downrod supplied with
your fan or an optional downrod purchased separately.
4. Position Fan/Motor Assembly on styrofoam, for ease of
assembly.
5. Loosen the two setscrews in the Downrod Support. Align
the Clevis Pin holes in the Downrod with the holes in the
Downrod Support. Install the Clevis Pin and secure with
the Hairpin Clip. (Figure 2) Be sure to push the straight
leg of the hairpin clip through the hole near the end of the
clevis pin until the curved portion of the hairpin clip snaps
around the clevis pin. The hairpin clip must be properly
installed to prevent the clevis pin from working loose. Pull
on the Downrod to make sure the clevis pin is properly
installed. (Figure 2)
6. While pulling up on the hanger ball, securely tighten the
two setscrews with nuts in the downrod support.
(Figure 2)
NOTE: The setscrews must be properly installed as
described above, or fan-wobble could result.
7. Install the Motor Coupling Cover as shown. (Figure 3)
Figure 2
Hairpin Clip
Downrod
Support
Figure 3
Motor
Coupling
Cover
Find Your Products By Category
Please Login
