Fanimation Fan Fanimation TF910WH Edgewood Wet Location Ceiling Fan In White User Manual

0

Out of 0 Ratings

Owner's of the Fanimation Fan Fanimation TF910WH Edgewood Wet Location Ceiling Fan In White gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 28
 
Assembling and Mounting the Fan Blades
9
Blade
Blade Holder
Arm
Figure 15
Figure 16
Do not connect fan blades until the fan is completely
installed. Installing the fan with blades assembled
may result in damage to the fan blades.
CAUTION
x 10
1/4-20 x 14mm
SCREWS
HARDWARE USED:
x 15
x 15
FLAT WASHER
3/16-24 x 7.5mm
PHILLIPS HEAD
SCREWS
HARDWARE USED:
1. Position the blade over the blade holder with
threaded posts showing. Make sure the bottom edge
of the blade is fully seated against the blade arm.
With a phillips screwdriver, tighten 3/16-24 x 7.5 mm
phillips head screws and flat washers to secure the
blade to the blade arm. (Figure 15)
To reduce the risk of electric shock, disconnect the
electrical supply circuit to the fan before installing
light kit.
CAUTION
To reduce the risk of personal injury, do not bend the
blade holders when installing, balancing the blades
or cleaning the fan. Do not insert foreign objects in
between the rotating blades.
WARNING
!
2. Secure the blade holders to the motor support
using the 1/4-20 x 14 mm screws throught the holes
located on the side of the motor support. (Figure 16)
NOTE:
Periodically check blade holder hardware and
resecure if necessary.

   Find Your Products By Category