Fanimation Fan Fanimation TF971AZ Edgewood Deluxe Wet Location Ceiling Fan In Aged Bronze User Manual

0

Out of 0 Ratings

Owner's of the Fanimation Fan Fanimation TF971AZ Edgewood Deluxe Wet Location Ceiling Fan In Aged Bronze gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 28
 
8
How to Wire Your Ceiling Fan
If you feel that you do not have enough electrical wiring knowledge or experience, have your fan installed by a
licensed electrician.
1. Connect the green grounding lead from the hanger
ball and the green grounding lead from the hanger
bracket to the supply grounding conductor (this may
be a bare wire or wire with gree colored insulation).
Securely connect wires with wire connectors supplied.
Household
Supply
Listed
Outlet Box
Black
Green Wire
(Ground) from
Hanger Bracket
Green Wire
(Ground)
Black
Fan Wire
White
Blue
Green Wire
(Ground) from
Hanger Bowl
Figure 11
▲
WARNING
To avoid possible electrical shock, be sure electricity is
turned off at the main fuse box before wiring.
NOTE: If you are not sure if the outlet box is grounded,
contact a licensed electrician for advice, as it must be
grounded for safe operation.
▲
WARNING
Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire
connectors, except for the ground wire. Do not operate
fan until the blades are in place. Noise and motor
damage could result.
Installing the Canopy Housing
Figure 12a
NOTE: This step is applicable after the necessary wiring
is completed.
▲
WARNING
To avoid possible fire or shock, make sure that the
electrical wires are completely inside the canopy housing
and not pinched between the housing and the ceiling.
x 3WIRE
CONNECTORS
HARDWARE USED:
3. Proceed to the next step of “Installing the
Canopy Housing“.
2. Securely connect the white fan motor wire the white
supply (neutral) wire using wire connector supplied.
Securely connect the black fan morot wire and blue
wire tho the black supply wire using wire connector
supplied (Figure 11). After connections have been
made, turn leads upward and carefully push leads into
the outlet box, withe the white and green leads on one
side of the outlet box ane the black and blue leads on
the other side ofh the outlet box.
Figure 12b
1. Remove one of the two shoulder screws in the
hanger bracket. Loosen the second shoulder screw
without fully removing it. Assemble canopy by
rotating key slot in canopy over shoulder screw in
hanger bracket. Tighten shoulder screw. Fully
assemble and tighten second shoulder screw that
was previously removed. (Figure 12a)
2. Securely attach and tighten the canopy screw cover
over the shoulder screws in the hanger bracket utilizing
the keyslot twist-lock feature. (Figrue 12b)

   Find Your Products By Category