0

Out of 0 Ratings

Owner's of the Sea Gull Lighting Fan Sea Gull Lighting Fan gave it a score of 0 out of 5. Here's how the scores stacked up:
  • Reliability

    0 out of 5
  • Durability

    0 out of 5
  • Maintenance

    0 out of 5
  • Performance

    0 out of 5
  • Ease of Use

    0 out of 5
of 12
 
Place blade holders onto blades aligning holes
in blade holder with holes in blade. Make sure
that the side of the blade you select is facing
downward. Install 3 screws and fiber wash-
ers to back side of blade as shown. Tighten
screws securely. Repeat this process 4 more
times until all blades are assembled.
Install blades to motor using the 10
motor screws provided. Tighten screws
securely.
 
Install 2 of the screws to the side panel
corresponding to the open slotted holes
on the canopy upper rim. Remove the all
thread studs from the lower part of the
mounting bracket.
Lift fan to mounting bracket, aligning the “L”
shape holes with the scresws on the mount-
ing bracket. Turn the fan clockwise to lock
in position. Install the 2 canopy mounting
bracket screws from the hardware pack and
tighten securely.


Hang fan from mounting bracket by
the hands free hook into a closed
hole on the edge of the Canopy.

Hands free hook
Make wire connections to power source using wire nuts
provided. Make sure that no filiments are outside of
the wirenut. After making the wire connections, the
wires should be spread apart with the grounded con-
ductor and the equipment-grounding conductor on one
side of the outlet box and ungrounded conductor on
the other side of the outlet box.

Connect black and blue wire from fan to Black or (Hot)
wire from house. Connect White wire from Fan to
White (Neutral) wire from house. Connect Ground
leads from mounting bracket and downrod to Ground
lead from house. +,+684!',+8="/577+)8/434,
2'39'1

497+
'3
Blue
Black
White
Green
Black
White
Ground
For Canadian installation in both flush and down-
rod mode the safety cable must be installed into
the house structure beams using the 3” lag screws
provided. Make sure that when the safety cable is
fully extended the leadwires are longer than the
cable and no stress is placed on the leadwires.

Canadian mounting only
Safety Cable
Lag Screw
Place the canopy over the yoke screws
aligning the large holes from the canopy
over the remaining screws of the yoke.
Reinstall the screws previously removed.

safety
cable
3” lag
screw
lock
washer
washer

   Find Your Products By Category