Craftmade Outdoor Ceiling Fan MOR54ESP3, MOR54MWW3 User Manual

0

Out of 0 Ratings

Owner's of the Craftmade Outdoor Ceiling Fan MOR54ESP3, MOR54MWW3 gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 26
 
page 10
10. Automated Learning Process./Activating Code.
CAUTION: The remote control transmitter can be programmed
to multiple receivers or fans. If this is not desired, turn wall switch
off to any other programmable receiver or fan.
This remote control transmitter is equipped with 16 code
combinations to prevent possible interference from or to
other remote units such as garage door openers, car alarms or
security systems. If you find that your fan and light go on and
off without using your remote control, simply change the
combination code in your remote control transmitter (and
wall control). To set the code, perform these steps:
Remove battery cover on back side of remote control
transmitter.
Use a ballpoint pen or a small screwdriver to set the code
switches 1 through 4 for the transmitter. Use the same
number sequence used when wiring the wall control in
Section 6 (page 7).
Note: The dimmer switch (labeled D and X) has been pre-set
to the "ON" position (D). If you do not wish to have dimming
capability, please move the switch to the "OFF" position (X).
Install one 12-volt battery (included) in transmitter. Re-attach
battery cover on transmitter.
IMPORTANT: Store the transmitter away from excess heat or
humidity. To prevent damage to transmitter, remove the
battery if not used for long periods.
Restore electrical power and then set slider switch on wall
control to the ON position. Within 30 seconds of turning on
the wall control, press the fan "OFF" button( ), located on
the front of the transmitter, for 5 seconds or until light blinks
twice. Test the light and fan functions to confirm the learning
process is complete--see Section 13.
battery
cover
12V battery
dimmer
switch
code
switches
transmitter
(back)
transmitter
(front)
11. Wall Control Operation.
ON/OFF slider switch - turns wall control ON or OFF
HIGH button - turns fan to HIGH speed
MED button - turns fan to MEDIUM speed
LOW button - turns fan to LOW speed
OFF button - turns fan OFF
L button - turns light ON/OFF when pressed once;
dims light when pressed and held down

   Find Your Products By Category